General Instructions - Hendi BAKE & GRILL-MASTER Mode D'emploi

General instructions

• Necessary changes may only be done by a qual-
ified technician
• Use only the supplied pressure regulator.
• This appliance is only suited for propane gas.
• Check that there are no kinks in the gas hose.
• The length of the gas hose may not exceed 1,5
meters.
• Keep the appliance away from (easily) flammable
material.
• Do not move the gas appliance during use.
• Always close the tap on the gas cylinder if the
appliance is no longer being used.
• The user must not change parts of the appliance
that are sealed by the manufacturer.
• Install the appliance as level as possible.
WARNING: Some parts of the appliance can become hot. Keep children away from the gas griddle.
Connecting the gas bottle
1 = main tap
2 = pressure regulator
EN
3 = gas hose
4 = gas bottle
Attach the pressure regulator to the gas bottle
using the large brass nut. Always ensure that the
rubber-sealing washer is present in the nut. (NB.
This rubber washer is not required for UK-type
pressure regulators). Tighten the nut well. Note
that the nut has a left-hand thread.
Check the connections for leaks using a soap and water solution.
Igniting the gas griddle
• Place the grill grid.
• Turn the knob to the "big flame" position. Keep
the knob pressed and press the ignition button a
few times until the burner is burning complete-
Turning off the gas griddle
• Turn the knob completely to the right. The burner will go off.
Note! After turning off the burners, wait approximately 10 minutes before reigniting the burners. After
turning off the burners, always turn off the main tap on the gas cylinder and the tap on the appliance!
6
• Before each use, the user must always check
whether the holes (pictured below) of the burner
are clear of obstructions and not blocked.
• Replacement of the gas bottle must be performed
outside the range of any sources of ignition.
ly. Keep the knob pressed in for approximately a
further 10 seconds. The burner will continue to
burn.