Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MCW-D 50 – Setting up
5.2
Function button of the MCW-D 523 / MCW-D 533 Chairman Microphone Unit
MCW-D 523 Chairman microphone unit
7
10
MCW-D 533 Chairman microphone unit
23
20
21
Depending on the configuration the following functions are possible with the
function button
or
: mute, clear or priority. The function button can be
10
23
configured via the control unit with the MCW-D 50 Conference software.
1. Normal
All delegate microphone units will be cleared and the microphone of the
chairman unit will be switched on. The delegates can switch on their micro-
phones again, when the chairman switches off his microphone.
2. Mute
All delegate microphone units which were activated before, will be muted
when the chairman is speaking and will be reactivated when the chairman
switches off his microphone.
3. Clear
All delegate microphone units are cleared and can be switched on
afterwards.
4. How to mute Aux-In ports
First push mutes the port, the next one enables it, third one mutes again etc.
If the chairman presses the priority button, the audio signal at the Aux Input
of the MCW-D 50 control unit will be muted. The LED
chairman unit will start flashing red (slowly). When the chairman turns on his
microphone, the LED
or
7
21
off priority the LED
or
will illuminate green permanently, if the micro-
7
21
phone is still on.
5. How to mute Aux-In ports & clear all active delegate unit
By pressing the priorty button a second time, AUX-In muting will be released.
By pressing the priority button a third time, the Aux-In ports will be muted
and all active delegate units will be cleared again, etc.
If the chairman presses the priority button, the audio signal at the Aux Input
of the MCW-D 50 control unit will be muted and all delegate units will be
cleared. The LED
or
of the chairman unit will start flashing red (slowly).
7
20
When the chairman turns on his microphone, the LED
green (slowly). If the chairman turns off priority the LED
illuminate green permanently, if the microphone is still on.
6. How to mute Aux-Out ports
First push mutes the port, the next one enables it, third one mutes again etc.
If the chairman presses priority, the audio signal at the Aux Output of the
control unit will be muted. The LED
flashing red (slowly). When the chairman turns on his microphone, the LED
or
will flash green (slowly). If the chairman turns off priority the LED
21
will illuminate green permanently, if the microphone is still on.
21
7. "COM Message" Function
A command is sent via the RS 232 serial interface from the MCW-D 50 control
unit and a programmed function is carried out via a media control system for
instance (e.g. light control).
8. Custom
Two different commands according to the duration of the push
< 1 second = command "Short press string" is transmitted
> 1 second = command "Long press string" is transmitted
These commands can be set individually with the MCW-D 50 Conference
Software.
or
20
7
will flash green (slowly). If the chairman turns
or
7
21
or
7
21
or
of the chairman unit will start
7
20
45
of the
will flash
will
7
or
7
Publicité
Chapitres
Table des Matières
Dépannage
