Connection Of Media Control System And Pc; Connecting And Positioning Of Remote Antennae - Beyerdynamic MCW-D 50 Notice D'utilisation

MCW-D 50 – Control Unit

3.2.9 Connection of Media Control System and PC

• If you want to connect a media control system and a PC to the MCW-D 50 control unit, connect the PC to the LAN network connection
and the media control system to the RS 232 connection
• For the direct connection of the LAN network connection to a PC you must use a null modem or crossover cable (female - female).
• The LAN settings are explained in the protocol of the MCW-D 50 Conference Software.
• The IP address of the MCW-D 50 control unit is 192.168.1.102 (Port 1024).
6 7
Important:
• Never access the MCW-D 50 control unit via the media control system and the MCW-D 50 Conference Software simultaneously.
In this case a correct function of the system cannot be guaranteed.
3.3

Connecting and Positioning of remote Antennae*

The MCW-D 50 control unit can also be operated with remote antennae. Low attenuation connecting cables are available in different lengths.
Please note that all three antennae have to be connected remotely. The transmitting antenna should be mounted in the centre and the
receiving antennae on the left and right hand side. The range can be increased by using a directional antenna (e.g. CA 2413, gain approx. 6 dB).
Depending on the cable attenuation you should use antenna amplifiers if the cables are long.
Installation with remote antennae*
refer to RX A
The CA 2413 planar antenna is connected to the MCW-D 50 control unit and mounted onto a stand with the CA 2462 mounting kit.
For more information refer to the "MCW-D Design Guide".
Important:
• There must be an unobstructed path between the microphone units and the antennae, i.e. between the MCW-D 50
control unit and the microphone units there must not be any obstacles. The range is around 30 - 50 m. For optimum
range the surface of the table is important, wood or plastic tables are ideal, but metal tables can cause interferences and reduce
the range.
• Please make sure that the minimum distance between the antennae and the microphone units is not less than 1 m.
*Important note for the USA and Japan: At present only the use of the CA 2413 remote antenna is permitted.
.
6
(1) MCW-D 50 control unit
(2) CA 2421/2422 or
CA 2431/2432 antenna cable
(3) CA 2413 planar antenna
(4) CA 2462 mounting kit 3/8"
(5) ST 600 stand 3/8"
37
7