Setting Up; Where To Place The Control Unit - Beyerdynamic MCW-D 50 Notice D'utilisation

MCW-D 50 – Control Unit
Rear
19
6 7 8
RS 232 port for the connection of PC or media control system (9-pin Sub-D).
6
Use a null modem or crossover cable (female - female).
LAN network connection for PC
7
Control LED for antenna powering 5 V DC (green = normal DC ; flashing red rapidly = short circuit)
8
Switch -10 dB / +15 dB for unbalanced input (RCA)
9
Input, RCA, unbalanced, for the connection of external devices such as CD players (L + R)
10
11 Output - master output, RCA, unbalanced, for the connection of external devices such as mixing consoles,
sound contracting systems or recorders (L + R)
12
Level control for Output - master output, RCA
Switch -10 dB / +15 dB for balanced input (XLR)
13
Input, 3-pin XLR female, balanced, for the connection of external sound sources (+6 dBm)
14
Output - master output, 3-pin XLR male, balanced, for the connection of external devices such as mixing consoles,
15
or sound contracting systems
ON/OFF-switch
16
Fuse
17
Mains supply
18
19 Connection for receiving antennae
20 Connection for transmitting antenna
3.2

Setting up

3.2.1 Where to place the Control Unit

• If you do not use remote antennae*, place the MCW-D 50 control unit in the room where the meeting takes place. If you use remote
antennae*, place them in the conference room.
• Do not place the MCW-D 50 control unit near digitally controlled equipment.
• Do not use the control unit outside.
*Important note for the USA and Japan: At present only the use of the CA 2413 remote antenna is permitted.
20
10 11 12 13 14 15
9
10
11
14
34
19
16 17 18