How To Switch The Control Unit On/Off; Channel Indication; Rack Mounting; Volume Control - Beyerdynamic MCW-D 50 Notice D'utilisation

MCW-D 50 – Control Unit

3.2.5 How to switch the Control Unit on/off

• Switch on the MCW-D 50 with the On/Off-switch
• During the first 30 seconds the MCW-D 50 control unit is started, the Power LED
operation is not yet possible. If the MCW-D 50 control unit is connected to a network via the LAN connection
control unit will be ready for operation after approx. 20 seconds.
• The Power LED on the front will illuminate green, when the control unit is ready for operation.
1
• CAUTION: Always turn off the power when making input or output connections.
Rear

3.2.6 Channel Indication

• Depending on the configuration of the MCW-D 50 control unit 3 or more channel-LEDs
Important:
• If the MCW-D 50 control unit is equipped with more than one module, but there are not more than 3 LEDs illuminated, please
check if individual modules have been deactivated with the MCW-D 50 Conference Software.

3.2.7 Rack Mounting

• When mounting the MCW-D 50 control unit into a 19"-rack housing leave 1 HU for a ventilation panel above and under the
control unit.
• Make sure that the mains switch, mains plug and all connection on the rear of the device are easily accessible.

3.2.8 Volume Control

• The volume of the microphone units is controlled with the virtual volume control of the MCW-D 50 Conference Software.
on the rear.
16
16
4
and the Channel LEDs
1
Front
1
will illuminate green (standard: 3 channels).
4
36
are flashing red and an
4
, the MCW-D 50
7