Dismantling And Repairs - Festo HMPL- Série Notice D'utilisation

HMPL-...
10

Dismantling and repairs

Replacing a shock absorber
1. Exhaust the HMPL-...
2. Remove the cover of the housing.
3. Loosen the locking nut on the shock ab-
sorber 4 .
4. Unscrew the shock absorber (spanner
area (A) on the shock absorber).
5. Remove the connecting clip (B), if still on
the shock absorber, and press onto new
shock absorber.
6. Screw in the new shock absorber as far as possible.
7. Tighten the locking nut again on the shock absorber (tightening torque see
"Commissioning").
8. Slowly pressurize and exhaust the end positions (connecting clip clicks into
place).
9. Replace and fasten the cover of the housing.
10. Carry out commissioning again (see the chapter "Commissioning").
S
Reduce the amount of waste by using the materials in the shock absorber for
other purposes (material recycling).
The shock absorber is filled with hydraulic oil. Due to the design refilling is not
possible.
If required:
S
Make sure that the HMPL-... is overhauled only by our repair service.
In order to dismantle the HMPL-...:
S
Exhaust the complete system and the linear module.
S
Order the relevant wearing parts if your HMPL-... shows the signs of wearing
listed.
Festo HMPL-... 0005NH – English
(B)
Fig. 31
4
(A)
33