Festo HMPL- Série Notice D'utilisation page 28

HMPL-...
7 Commissioning
Warning
There is a danger of injury caused by the
sudden release of pneumatic forces.
S Make sure that:
– nobody can place his/her hand in the
path of the moveable mass (e.g. by
providing a protective grill)
– there are no objects in the positio-
ning range of the HMPL-... .
Please note
If the shock absorbers are loose, the cushioning effect will be considerably
reduced.
S Make sure that the shock absorbers are screwed in completely and locked
(as supplied from the factory).
For rough adjustment of an end position:
S
Carry out the following steps:
1. Exhaust the HMPL-...
2. Loosen the locking nut of the stop el-
ement with an open-ended spanner until
the flanged nut aD can be turned.
3. Roughly adjust the flanged nut in the
desired end position. The groove for the
proximity switch must not be pushed
under the flow control valve.
The following maximum end positions of
the stop element are permitted:
– screwed in flush (as supplied from
factory)
– the thread of the stop element projects
with maximum length X (see Fig. 23).
28
Fig. 20
Fig. 21
Fig. 22
Festo HMPL-... 0005NH – English