Appendix; Safety Precautions; Cleaning The Unit; Troubleshooting - Sony UPA-PC500 Mode D'emploi

Appendix

Safety Precautions

• Operate the unit on 100 to 240 V AC, 50/60 Hz only.
• Be careful not to set or drop any heavy objects on the
power cord, or to damage the power cord in any way.
Never operate this unit with a damaged power cord.
• To disconnect the power cord, pull it out by the plug.
Never pull the power cord itself.
• To reduce the risk of electrical shock, always
disconnect the unit from the power outlet before
cleaning and servicing the unit.
• If any solid object or liquid falls into the cabinet,
unplug the unit and have it checked by qualified
personnel before operating it any further.
• If the unit will not be used for an extended period,
disconnect the power cord from the power outlet.
• The unit's touchscreen is made of glass. Take care not
to scratch or damage the touchscreen.
• Do not jar or drop the unit.
• Do not handle the unit roughly.
• Never disassemble the unit.
Condensation
If the unit is brought directly from a cold location to a
warm one or is placed in an extremely warm or humid
room, water droplets may form inside the unit. (This is
called "condensation.") Using the unit in this condition
could damage the unit or cause it to malfunction. If you
think that condensation may have formed inside the unit,
allow time for it to evaporate before using the unit.

Cleaning the Unit

• Before cleaning the unit, always turn off the unit and
disconnect the power cord from the power outlet.
• If the cabinet is dirty, soak a clean cloth in a solution
of water and neutral detergent, wring out the cloth
thoroughly, and wipe the surface of the cabinet. Then
use another clean, dry cloth to wipe the cabinet dry.
• If the surface of the display is dirty, soak a clean cloth
in a solution of water and neutral detergent, wring out
the cloth thoroughly, and wipe the surface of the
display. Then use another clean, dry cloth to wipe the
screen dry.
• To avoid damaging the surfaces of the unit, never use
thinner, benzene, alcohol, or any other type of organic
solvent to clean the unit.
18
Safety Precautions / Troubleshooting

Troubleshooting

Before sending the unit out for servicing, check the
items listed below. If you still cannot solve the problem,
contact your Sony Authorized Dealer.
Problem Cause/Remedy
tThe power cord may not be
Power does not turn
on. connected.
Make sure the power cord is
connected to a power outlet.
tThe 1 button may not have been
pressed correctly.
Make sure the 1 button on the rear
of the unit is fully depressed.
Power does not turn tThe unit may still be processing.
off. Wait a few moments for the unit to
stop processing.
tA malfunction may have caused the
unit to stop responding.
Press and hold the 1 button on the
rear of the unit for at least four
seconds to perform an emergency
shutdown.
Image data cannot be tThe media does not contain any
read. data.
Insert media that contains image
data.
tData has been recorded on the
media in a format that the unit does
not recognize.
Make sure to store image data in a
format that the unit can recognize
(page 19).
tThe media may not be properly
inserted.
Make sure the media is inserted
correctly.
tThe disc may have been inserted
Image data cannot be
read from a disc. with the label side (the printed side)
facing down.
Make sure to set the disc in the
drive tray with the label facing up.