Important Notes; Power Supply - Boss eBand JS-10 Mode D'emploi

WARNING
Do not share an outlet with an unreasonable
number of other devices
Do not force the unit's power-
supply cord to share an outlet with
an unreasonable number of other
devices . Be especially careful when
using extension cords—the total
power used by all devices you have
connected to the extension cord's
outlet must never exceed the power
rating (watts/amperes) for the
extension cord . Excessive loads can
cause the insulation on the cord to
heat up and eventually melt through .
Do not use overseas
Before using the unit in a foreign
country, consult with your retailer,
the nearest Roland Service Center, or
an authorized Roland distributor, as
listed on the "Information" page .
CAUTION
Place in a well ventilated location
The unit and the AC adaptor should
be located so their location or
position does not interfere with their
proper ventilation .

IMPORTANT NOTES

Power Supply

• Do not connect this unit to same electrical
outlet that is being used by an electrical
appliance that is controlled by an
inverter or a motor (such as a refrigerator,
washing machine, microwave oven, or air
conditioner) . Depending on the way in which
the electrical appliance is used, power supply
noise may cause this unit to malfunction
or may produce audible noise . If it is not
practical to use a separate electrical outlet,
connect a power supply noise filter between
this unit and the electrical outlet .
• The AC adaptor will begin to generate heat
after long hours of consecutive use . This is
normal, and is not a cause for concern .
• To prevent malfunction and equipment
failure, always make sure to turn off the
power on all your equipment before you
make any connections .
CAUTION
Grasp the plug when connecting or disconnecting
the AC adaptor
Always grasp only the plug on the
AC adaptor cord when plugging into,
or unplugging from, an outlet or this
unit .
Periodically clean the AC adaptor's plug
At regular intervals, you should
unplug the AC adaptor and clean
it by using a dry cloth to wipe all
dust and other accumulations away
from its prongs . Also, disconnect the
power plug from the power outlet
whenever the unit is to remain
unused for an extended period of
time . Any accumulation of dust
between the power plug and the
power outlet can result in poor
insulation and lead to fire .
Manage cables for safety
Try to prevent cords and cables from
becoming entangled . Also, all cords
and cables should be placed so they
are out of the reach of children .
Avoid climbing on top of the unit, or placing heavy
objects on it
Never climb on top of, nor place
heavy objects on the unit .
• With the factory settings, the JS-10 will
automatically be switched off 30 minutes
after you stop playing or operating the
unit . If you don't want the unit to turn off
automatically, change the "AUTO OFF" setting
to "OFF" as described on p . 26 .
* The settings you were editing will be lost when the
unit is turned off . If you want to keep your settings,
you must save your settings before turning the
unit off .
Placement
• Using the unit near power amplifiers (or
other equipment containing large power
transformers) may induce hum . To alleviate
the problem, change the orientation of this
unit; or move it farther away from the source
of interference .
• This device may interfere with radio and
television reception . Do not use this device
in the vicinity of such receivers .
• Noise may be produced if wireless
communications devices, such as cell
phones, are operated in the vicinity of this
unit . Such noise could occur when receiving
or initiating a call, or while conversing .
Should you experience such problems, you
should relocate such wireless devices so they
are at a greater distance from this unit, or
switch them off .
IMPORTANT NOTES
CAUTION
Do not connect or disconnect the AC adaptor with
wet hands
Never handle the AC adaptor or
its plugs with wet hands when
plugging into, or unplugging from,
an outlet or this unit .
Disconnect everything before moving the unit
Before moving the unit, disconnect
the AC adaptor and all cords coming
from external devices .
Unplug the AC adaptor from the outlet before cleaning
Before cleaning the unit, turn it off
and unplug the AC adaptor from the
outlet (p . 4) .
If there is a possibility of lightning strike, disconnect
the AC adaptor from the outlet
Whenever you suspect the possibility
of lightning in your area, disconnect
the AC adaptor from the outlet .
Keep small items out of the reach of children
To prevent accidental ingestion
of the parts listed below, always
keep them out of the reach of small
children .
• Included Parts
SD Card (p . 28)
• Removable Parts
USB caps (p . 4),
SD CARD slot cover (p . 28),
screw (p . 28)
• Do not expose the unit to direct sunlight,
place it near devices that radiate heat, leave
it inside an enclosed vehicle, or otherwise
subject it to temperature extremes . Excessive
heat can deform or discolor the unit .
• When moved from one location to another
where the temperature and/or humidity is
very different, water droplets (condensation)
may form inside the unit . Damage or
malfunction may result if you attempt to use
the unit in this condition . Therefore, before
using the unit, you must allow it to stand for
several hours, until the condensation has
completely evaporated .
• Depending on the material and temperature
of the surface on which you place the unit, its
rubber feet may discolor or mar the surface .
You can place a piece of felt or cloth
under the rubber feet to prevent this from
happening . If you do so, please make
sure that the unit will not slip or move
accidentally .
• Avoid the use of insecticides, perfumes,
alcohol, nail polish, spray cans, etc ., near the
unit . Swiftly wipe away any liquid that spills
on the unit using a dry, soft cloth .
41