Boss eBand JS-10 Mode D'emploi page 37

DELAY
This effect adds delayed sound to the direct sound, giving more
body to the sound or creating special effects .
Parameter/
Explanation
Range
ON/OFF
OFF, ON Turns the DELAY effect on/off .
DELAY TIME
1ms–1000ms (*) This determines the delay time .
FEEDBACK
This sets the amount of delay sound returned to the
input .
0–100
A higher value will increase the number of the delay
repeats .
HIGH CUT (High Cut Filter)
This sets the frequency at which the high cut filter
630Hz–12 .5kHz,
begins to take effect . When "FLAT" is selected, the high
FLAT
cut filter will have no effect .
EFFECT LEVEL
0–120 Adjusts the volume of the delay sound .
REVERB
This effect adds reverberation to the sound .
Parameter/
Explanation
Range
ON/OFF
OFF, ON Turns the REVERB effect on/off .
TYPE
This selects the reverb type . Various different simulations of space are
offered .
Simulates an ambience mic (off-mic, placed at a
distance from the sound source) used in recording
AMBI .
and other applications . Rather than emphasizing the
(AMBIENCE)
reverberation, this reverb is used to produce a sense of
openness and depth .
Simulates the reverberation in a small room . Provides
ROOM
warm reverberations .
Simulates the reverberation in a concert hall . Provides
HALL
clear and spacious reverberations .
Simulates plate reverberation (a reverb unit that uses
PLATE the vibration of a metallic plate) . Provides a metallic
sound with a distinct upper range .
REV TIME (Reverb Time)
0 .1 s–10 .0 s Adjusts the length (time) of reverberation .
HIGH CUT (High Cut Filter)
This sets the frequency at which the high cut filter
630Hz–12 .5kHz,
begins to take effect . When "FLAT" is selected, the high
FLAT
cut filter will have no effect .
EFFECT LEVEL
0–100 Adjusts the volume of the reverb sound .
EZ CHAR
Parameter/
Explanation
Range
EZ CHAR (EZ Character)
Increasing the value makes the tone suitable for solos
-20–+20
and decreasing it makes the tone suitable for backing .
WAH
You can control the wah effect in real time by stepping on the
expression pedal connected to the EXP PEDAL/CTL 1, 2 jack .
MEMO
WAH can be used in effects for the INPUT 1 jack .
Parameter/
Explanation
Range
ON/OFF
OFF, ON
Turns the WAH effect on/off .
Setting parameters with Tap Tempo
The values for the parameters marked with an asterisk (*)
can be set so they match the timing you use when pressing
the [SPEED] button (Tap Tempo) .
Tap the [SPEED] button two or more times in succession to
specify a tempo for the parameter .
Appendices
35