EINHELL E-HKS 1500-Laser Mode D'emploi page 8

Anleitung E-HKS 1500 Laser
GB
1. Description
1. Handle
2. Ratingplate
3. On/Off switch
4. Interlock button for On/Off switch
5. Locking lever for setting the cutting depth
6. Power cable
7. Splitter
8. Hinged guard hood
9. Allen screw
10. Shoe
11. Flange
12. Saw blade
13. Parallel stop
14. Lock screw for the parallel stop
15. Lock screws for mitre cuts
16. Dust extractor connection
17. Additional handle
18. Actuator for the hinged guard hood
19. Face spanner
20. Laser attachment
21. Allen key
Please read these instructions carefully and pay
particular attention to the safety regulations. Keep
the instructions together with the circular saw.
2. Technical data
Voltage 230 V ~ 50 Hz
Power rating
Idle speed
Cutting depth at 0°
Cutting depth at 45°
Saw blade 190 mm dia.
Saw blade mount 20 mm dia.
Saw blade thickness
Sound pressure level LPA 99 dB(A)
Sound power level LWA 112 dB(A)
Vibration a < 2,5 m/s
W
Weight
Totally insulated
Laser class
Laser wave length
Laser output
Laser module power supply
2 x 1,5 V button cell battery
8
08.04.2004 8:25 Uhr
3. Applications
The hand-held circular saw is designed for sawing
straight cuts in wood, in materials similar to wood,
and in plastics.
4. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Important!
Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open the laser module.
When the device is not going to be used for
1500 W
an extended period of time, the batteries should
4500 rpm
be removed.
66 mm
47 mm 5. Working with the hand-held
circular saw
Always hold the circular saw firmly.
2,8 mm
The hinged guard hood will be pushed back
automatically by the workpiece.
Never apply force! Advance the circular saw gently
and steadily.
2
The off-cut piece should be to the right of the
5,1 kg
circular saw so that the wide part of the base plate
II /
is supported over its entire surface.
2
When sawing along a marked line, guide the
circular saw along the corresponding groove.
650 nm
Clamp small pieces of wood securely before
≤ 1 mW
sawing. Never hold them in your hand.
Always observe the safety regulations! Wear
goggles!
Do not use defective saw blades or blades with
cracks or flaws.
Seite 8