DeWalt DWE46152 Guide D'utilisation page 7

For optimal positioning, the diamond wheel should
ride above the brushes 1/8" (3.18 mm). If diamond
wheel rides inside the shroud or stands taller than 1/4"
(6.35 mm) the shroud will not work properly.
NOTICE: If surface grinding shroud cannot be
tightened by the clamp adjusting screw, do not use
the tool and take the tool and surface grinding shroud
to a service center to repair or replace the surface
grinding shroud.
5. To remove the surface grinding shroud, loosen the
clamp adjusting screw, rotate the surface grinding
shroud to align the slots and tabs and pull up on the
surface grinding shroud.
Mounting Dry Diamond Surface Cup
Wheels (Fig. C)
Follow the mounting and using cutting wheels instructions
in the tool manual and mount the grinding wheel. DO NOT
use Type 1 cutting wheels or bonded abrasive wheels.
Dry diamond surface cup 10
use with this shroud. The inner flange washer
installed behind the wheel allowing free tool removal and
proper fit.
Fig. C
10
11
Dust Extraction (Fig. A, D)

WARNING: Use only power tools recommended by
D WALT with this attachment.
e
For more information about D
compatible with this attachment, please contact your local
dealer, call 1–800–4-D WALT (1–800–433–9258) or visit our
e
website www.D WALT.com.
e

WARNING: This attachment must be used with a dust
extractor system. ALWAYS wear certified safety face
or dust mask.
nOTE: Ensure hose connection is secure.
nOTE: The amount of dust retained by the dust extractor
vacuum is dependent on its filter system. Refer to the dust
extractor vacuum instruction manual for more information.
All D WALT dust collection shrouds are designed to work
e
with the D WALT universal DWV9000 connector.
e
1. Attach the DWV9000 connector
collector hose 13 .
2. Unlock the DWV9000 connector
port .
1
wheels are recommended for
11 should be
WALT power tools
e
12 to your dust
12 and slide onto dust
3. Lock the DWV9000 connector
Fig. D
13
1
Traditional dust extractor vacuum
hoses
Attach recommended dust extractor vacuum hose to dust
port 1 .
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury. This applies
to both the grinder and the dust extractor
vacuum. Such preventative safety measures reduce
the risk of starting the tool accidentally.

WARNING: For your own safety, read the instruction
manual for both the grinding tool and the dust
extractor vacuum before using any accessory. Failure
to heed these warnings may result in personal
injury and serious damage to the tool and the
accessory. When servicing this tool, use only identical
replacement parts.
nOTE: The amount of dust retained by the dust extractor
vacuum is dependent on its filter system. Refer to the dust
extractor vacuum instruction manual for more information.
1. Ensure all assembly instructions have been completed.
2. Turn the dust extractor vacuum on as instructed in the
dust extractor vacuum instruction manual.
3. Turn the tool on as instructed in the tool instruction
manual and allow it to reach full speed before making
contact with work surface.
4. Place the surface grinding shroud to flat work surface
such as a floor or wall and begin grinding.
English
12 to secure.
12
5