Electrical Connection - HBM C16A Manuel D'emploi

7

Electrical connection

C16A
The following can be connected for measurement signal
conditioning:
S carrier-frequency amplifiers
S DC amplifiers
designed for strain gage measurement systems.
The transducers are supplied in the standard version in a
six-wire configuration with open cable ends.
Notice
Lay the cables so that no wear points can occur due to
the natural motion of the transducer and so that no dam­
age occurs to the cable sheath.
Tip
Route the connection cable so that any condensed water
or dampness forming on the cable can drip off. It must
not be conducted to the transducer (use small loops).
Also ensure that no moisture can penetrate the open
cable ends.
A1460-4.0 HBM: public
Electrical connection
21