Using "Manual" Massage; When Using A Combination Of Several Massage Operations - Panasonic EP-MA03 Mode D'emploi

Fauteuil vibromasseur.
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USING "MANUAL" MASSAGE

Avoid massaging any one part of your body for more than 5 minutes at a time.
Failure to observe this may result in an adverse effect or injury.
Press the
(The power will turn off automatically if no operation is performed within 3 minutes.)
Basic massage (when used with a single operation)
1
Select the types of massage using the
Select the types of massage from Neck roll, Neck knead, Knead, Tap and Back roll.
* *The selected type
2
Press
buttons when
selecting a massage
operation.
* The chosen operation is encircled by a frame.
3
Press the
The massaging position is automatically set.
The massage starts with the selected operation.
If "Neck roll," "Neck knead," or "Back roll" are selected, the
operation starts by the approximate location of the
shoulders being checked.
(Foot massaging does not simultaneously start)

When using a combination of several massage operations

(Example) When selecting "Knead (Upwards)", "Tap(Normal)" and "Back roll(Partial)"
1. Use the
buttons
to select the type of
"knead" massage.
5.
Press the
button to operate.
To cancel the selection of a massage operation while setting an operation
Press
button to cancel a framed operation which is selected.
18
button to select preferred massage operating mode.
flashes.
button.
(See page 14.)
2. Select "Knead upwards"
with
button.
* The chosen operation is
encircled by a frame.
<Note>
Select the massage type using
combinations of available massage types are displayed.
[Example]
If "Neck roll" is selected, "Tap (Normal)" or "(Soft)" can be selected.
buttons.
<Types of massage>
Type
1
Neck roll
2
Neck knead
3
Knead
4
Tap
5
Back roll
<Note>
If the
button is pressed without an operation being
selected, the same operation will be selected that was
operated when the
button was pressed once.
When choosing an operation, the selection sequence can be
reversed by pressing
button.
3. Align with "tap" via
the
button, and
select operation
"Normal" with
button.
* The chosen operation
is encircled by a frame.
buttons, if
button is pressed the
Operation
Neck roll
Neck knead
Knead downwards
Knead upwards
Normal
Soft
Full
Partial
4. Select "Back roll"
with
button and
"Partial" with
button.
* The chosen operation
is encircled by a
frame.

Publicité

Table des Matières
loading

Table des Matières