Proper Use - Ryobi ETMS-1426 Manuel D'utilisation

GB
F D
DESCRIPTION
27. Stop rail
28. Lock plastic knob for cutting width
29. Push stick
30. Splitter
31. Dust extractor port
32. Clamping device
33. Recessed head screw
34. Table insert, top
35. Adjustable stop
36. Lock screw for workpiece support
37. Dust bag
38. Allen screws
39. Removeable blade guard
40. Recessed head screws
41. Middle recessed head screw

PROPER USE

This Table Top mitre saw with upper table is designed for
making cross cuts, longitudinal cuts and mitre cuts
(using the stops) in timber and plastic commensurate with
the machine's size. It is not suitable for cutting fire wood.
The machine is to be used only for its prescribed purpose.
Any use other than that mentioned is considered to be a
case of misuse. The user/operator and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse. The machine is to
be operated only with suitable saw blades. It is prohibited
to use any type of cutting-off wheel. To use the machine
properly you must also observe the safety regulations,
the assembly instructions and the operating instructions
to be found in this manual.
All persons who use and service the machine have to be
acquainted with this manual and must be informed about
its potential hazards. It is also imperative to observe the
accident prevention regulations in force in your area.
The same applies for the general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting from
such changes. Even when the machine is used as
prescribed it is still impossible to eliminate certain
residual risk factors. The following hazards may arise in
connection with the machine's construction and design:
Contact with the saw blade in the uncovered
■
saw zone.
Reaching into the running saw blade (cut injuries).
■
E I P NL S DK N FIN
English
Kick-back of workpieces and parts of workpieces due
■
to improper handling.
Saw blade fracturing.
■
Catapulting of faulty carbide tips from the saw blade.
■
Damage to hearing if essential ear-muffs are not worn.
■
Harmful emissions of wood dust when the machine is
■
used in closed rooms.
BEFORE PUTTING THE MACHINE INTO
OPERATION (FIG. 1-3)
General information
The machine has to be set up where it can stand
■
firmly, e.g. bolt it to a work bench, a universal base
or similar.
All the covers and safety devices have to be properly
■
fitted before the machine is switched on.
It must be possible for the saw blade to run freely.
■
When working with wood that has been processed
■
before, watch out for foreign bodies such as nails or
screws etc.
Before you actuate the On/Off switch, make sure that
■
the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power supply,
■
make sure the data on the rating plate is the same as
that for your mains.
Converting the combination saw (Fig. 1-4)
The saw has two working positions:
A: Table saw (Fig. 1)
B: Mitre saw (Fig. 2)
To convert the saw from one working position to
another, proceed step by step exactly as described
below or you may damage components.
CAUTION
Pull out the power plug each time before you
convert the saw!
The saw is delivered in working position A (Table saw).
Converting to mitre saw mode
Press down the machine head by the handle (2) and
■
pull out the retaining pin (23). This disconnects the
power supply to the switch (4) for table saw mode
and connects it to the switch (3) for mitre saw mode.
12
GR H CZ RUS RO PL