Troubleshooting Guide - EINHELL BG-PM 51 S HW-E Mode D'emploi D'origine

9. Troubleshooting guide

Warning: Switch off the engine and pull out the spark plug boot before making any checks or adjust-
ments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remem-
ber that the exhaust and other parts will get hot. Do not touch these parts as they may burn you.
Fault
The equipment - Bolts loose
does not operate - Blade attachment is loose
smoothly and vibra- - Blade imbalanced
tes intensively
The engine does - Engine start/stop lever is not
not start pressed
- Throttle lever in wrong position
- Spark plug defective
- Fuel tank empty
Engine does not run - Air fi lter dirty
smoothly - Spark plug dirty
Lawn turns yellow, - Blade is not sharp
uneven cut - Cutting height too small
- Engine speed too low
Grass chute is not - Engine speed too low
clean - Cutting height too small
- Blade is worn
- Grass bag is clogged
The battery does - Poor plug contact to the battery
not charge up - Battery defective
- 5A fuse (Item 19) is defective
Starter does not - Battery discharged
turn - Battery not connected
- No plug-in connections
Anl_BG_PM_51_S_HW_E_SPK7.indb 42 Anl_BG_PM_51_S_HW_E_SPK7.indb 42
GB
Possible cause
- Check bolts
- Check blade attachment
- Replace blade
- Press the engine start/stop lever
- Check setting
- Replace spark plug
- Top up fuel
- Clean the air fi lter
- Clean the spark plug
- Sharpen blade
- Adjust to the proper height
- Set the lever to max.
- Set the throttle lever to max.
- Set properly
- Replace the blade
- Empty the grass bag
- Clean the contacts
- Have the battery checked by an
expert and replace it if necessary
- Check the function of the equip-
ment using a diff erent battery; re-
place the fuse
- Charge the battery
- Connect the battery
- Check the plug-in connections
- 42 -
Remedy
20.02.12 09:27 20.02.12 09:27