BEKA HAMAX 2 Mode D'emploi page 33

Change of the pump
The pump ing element is also
To be able to remove the pump
effect, you need a 8 mm hexagon
the system. To this effect, screw the
element.
Fig. 10:
6 5 4
When installing the new pump
located in the appropriate groove (Fig. 10: item 3). Then, insert the pum
feather key locks into the groove in the pump
10: item 5). Grease the O- ring (Fig. 10: item 6) located on the lockscrew slightly.
Caution!
ing element
available s a a spare part :
To remove the pumping element, make sure that the system is depressurized.
ing element, remove the lockscrew on the front of the pump housing (Fig. 10: item 5). To this
key. To pull out the pump
pulling device (Fig. 10: item 2) into the thread (Fig. 10: item 4) on the front of the pump
5
3
2 1
ing element, make sure that no dirt gets into the pump. Moreover, the feather key must be
casing . Clamp the pump
When using copper paste, you must replace the pump
service hours due to the solids content!
...a product of BEKA
PE 120FH
ing element (Fig. 10: item 1), use the
ping element into the locating bore-hole so that the
ing element again by means of the new lockscrew (Fig.
order-no.: 2576GE0001
pulling device supplied with
ing element after approx. 100
GB
ing
33
0