BEKA HAMAX 2 Mode D'emploi page 23

Safety labeling
All system components have been designed in view of operating safety and accident prevention according to the applicable
provisions for the design of technical equipment.
Nevertheless, utilization thereof may result in risks for the user or third parties and/or other technical equipment. Thus, the
system may only be used in proper technical working order within its intended fields of application and in compliance with the
safety provisions and the Operating Instructions.
Any safety-related faults must be eliminated without delay.
Below, please find fundamental instructions to be complied with as regards assembly, operation and maintenance. The
mechanic and the competent specialists / staff of the operating company must read the Operating Instructions on all accounts
prior to starting assembly and commissioning. Moreover, the Operating Instructions must be permanently available on site.
Not only the safety instructions included under this item, but also the specific safety instructions appearing in other parts of
this manual must be complied with.
The staff in charge of operation, maintenance, inspection and assembly must be qualified accordingly for this work. The
operating company must stipulate competences, responsibilities and the supervision of staff precisely. If the staff does not
dispose of the appropriate knowledge, they must be trained and instructed. The operating company must ensure that the staff
have fully understood the contents of the Operating Instructions.
Non-compliance with the safety instructions may rule out any claims for damages. Non-compliance may lead, e.g. to the
following dangers:
· Failure of important system functions
· Failure of the specified maintenance and servicing methods
Non-compliance with the safety provisions may put persons at risk and endanger the
environment and/or the machine.
...a product of BEKA
GB
23