BEKA HAMAX 2 Mode D'emploi page 30

Grease cartridges
The grease pump BEKA HAMAX System 2 features an adapter system which enables the use of three cartridge types.
Type S - Standard:
Quantity: 400 g
GB
Type F:
Quantity: 500 g
T yp L: e
Quantity: 400 g
30
Typ Ra:
Change of the cartridge
Before installing the cartridge, grease the
Fig . 5: 1
To accelerate priming, first remove the cap from the cartridge opening, then, using the cartridge follower piston (Fig. 5:
item 3) press out grease by 5 mm to 10 mm (Fig. 6).
Subsequently, insert the cartridge in the adapter holder by pressing it slightly, and fasten it by hand. In case of initial
equipment, fill the lubricant line by means of the grease nipple on the front side of the pump (see Fig. 1: item 11). If the
cartridge follower piston (Fig. 5: item 3) is at the bottom of the cartridge, the latter must be replaced. The follower piston can be
checked easily through the inspection
Note!
...a product of BEKA
O- ring (Fig. 4: 1, 2) located in the adapter slightly.
4 2
window (Fig. 5: item 4) in the pump
When replacing the cartridge, make sure that no contamination enters the intake area
of the cartridge!
Typ R:
s
3 Fig . 6
casing
Fluid Order-No.
EP2-grease 0320092
Cu-paste 0320091
EP2-grease 0320089
Cu-paste 0320090
or in the adapter.