Maintenance & Storage - Haussmann 8401019 Manuel D'utilisation

OPERATING INSTRUCTIONS
To manually feed the line (See L)
Fig L
If required line can be feed out manually.
To operate, press and release manual line feed
button (18), while gently pulling out the lines
until the lines reach the line cutter.
When the required amount of line is fed out,
gently pull on the second line (there is no need
to press the manual line feed button again)
If the line extends past the line cutter, too much
line has been fed out.
If too much line is fed out, remove the spool cap
and turn spool counter-clockwise until the line is
at the desired length.
To remove the cap (See M)
Press and hold in the two latches.
Pull cap away from the spool holder
Keep all areas of the cap and spool holder
clean.
Replace the cap, pressing firmly down towards
the spool holder to ensure cap is fully located.
Check that the cap is correctly fitted by trying to
remove it without depressing the two latches.
Fig M
A
To replace cut line.
For your convenience it is recommended you
buy spool and line complete.
To fit spool and line complete:
18
Remove old spool.
Place new spool into cap with cut out areas of
the spool in line with eyelets.
Release line from cleat and feed line through eyelet .
Refit the cap.
To fit nylon line only:
18
Take approximately 16ft (5m) of line. Insert 5/8"
(15mm) of line into the spool holes and wind
line in the direction of the arrows on the top of
the spool.
Your trimmer is designed to use only line with a
maximum diameter of 0.065"
IMPORTANT :Leave approximately 4"(100mm)
of line unwound and place into cleat.
Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will
impair the efficiency of the automatic line feed.
Then fit spool as described in "To fit spool and
line complete".
STORING YOUR STRING TRIMMER
Store in a dry place where your trimmer can
be protected from water and other damage.
MAINTENANCE & STORAGE
After use, disconnect the battery pack from
the tool and check for damage. Your power
tool requires no additional lubrication or
maintenance. There are no user serviceable
parts in your power tool. Battery-powered
trimmers should only be repaired by an
authorized repairer; use only manufacturer-
recommended replacement parts and
accessories.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a
dry cloth. Always store your trimmer in a dry
place out of the reach of children. Keep the
motor ventilation slots clean. Keep all working
controls free of dust.