Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
WARNING!Do not let the blade come into contact with fencing wire or any
other object that could damage it.
Fig.4
Shaping(Fig.5)
1.
Trim the hedge to make it wider at bottom than the top. This improves
penetration of light and promotes healthy growth.
2.
Taper the hedge approximately 4 inches (100 mm) for every 40
inches (1 meter) in height. A bush can be round or a column shape.
MAINTENANCE
WARNING!Always ensure that the tool is switched off and the plug
is removed from the power source before making any adjustments or
performing maintenance procedures.
1.
Check your tool regularly before starting the work.
2.
Damaged cutting blades have to be repaired or exchanged by a
authorized service facility before working with the tool.
3.
After each cutting operation, clean the cutting blade with a soft
brush and cloth with lubricating fluid oil and spray a thin layer of fluid
protective oil on the completes blade.
Always keep the ventilation slots in motor housing clean.
4.
5.
Never clean or spray the tool with water. Clean the motor housing only
with a moist cloth and never apply detergents or solvents! These could
ruin the plastic parts of the tool. Finally, dry the motor housing carefully.
6.
Store the tool with the blade sheath.
7.
Only original accessories and spare parts can be repaired or replaced.
Lubrication
After each use, clean the blades and lightly lubricate with general purpose
oil or spray lubricant.
WARNING!Switch tool off and unplug from power source before carrying
out any maintenance on the tool.
Fig.5
9
Publicité
Table des Matières
