LawnMaster GT1450 Manuel D'utilisation page 10

ASSEMBLY
WARNING
Before assembly, make sure that the grass trimmer is switched off and
unplugged.
FITTING THE GUARD
1. Place the guard onto the grass trimmer as shown in Figure 2 and rotate the guard in position
in Figure 3.
2. Secure the guard with the screw.
ASSEMBLE THE FLOWER GUARD
1. Pull the flower guard wide enough to extend wide enough to fit over the moter housing.
2. Put both ends of the steel bar into the recessed cavities on the motor housing.
WARNING
Never use the grass trimmer unless the guard is properly fitted.
(See Figure 2 & Figure 3.)
Fig. 2
(See Figure 4 & Figure 5.)
Fig. 4
10
Fig. 3
Fig. 5