Makita RT0702CX2J Manuel D'instructions page 12

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Collet chuck capacity
No load speed
Overall height
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The net weight value includes the lightest and heaviest combination of the attachment(s) for normal and safe
use which are specified in the instruction manual.
Intended use
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-17:
Sound pressure level (L
Sound power level (L ) : 93 dB (A)
WA
Uncertainty (K) : 3 dB (A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
can also be used in a preliminary assessment of
exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
total value(s) depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
) : 85 dB (A)
pA
Vibration
The continuous vibration total value (tri-axial vector
sum) determined according to EN62841-2-17:
Work mode: rotation without load
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration total value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration total value(s) can also
be used in a preliminary assessment of exposure.
WARNING:
actual use of the power tool can differ from the
declared total value(s) depending on the ways in
which the tool is used.
WARNING:
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
The following shows the mean values of the peak ampli-
tude of the acceleration from repeated shock vibrations,
, with corresponding uncertainty (K) determined
p
F
according to EN62841-2-17.
Work mode: rotation without load
2
p : 22 m/s
F
Uncertainty (K) : 1 m/s
NOTE: These declared values should not be used to
determine hand arm vibration exposure.
Declarations of Conformity
For European countries only
The EU/UK Declaration of Conformity can be accessed
from the following URL.
12 ENGLISH
RT0702C
6 mm, 8 mm, or 1/4"
-1
10,000 - 34,000 min
210 mm
1.8 - 2.8 kg
/II
2
) : 0.7 m/s
h
2
The vibration emission during
Be sure to identify safety mea-
2