Safety Information - Velleman DVM9912 Notice D'emploi

DVM9912 – AUTORANGING MULTIMETER
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a
specialised company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the DVM9912! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, don't install or use it and contact your dealer.

2. Safety information

The following safety information must be observed in order to ensure maximum personal safety during the use
of this device.
• Do not use the meter if the meter or the test leads look damaged or if you suspect the meter is not
operating properly.
• Never ground yourself when taking electrical measurements. Do not touch exposed metal pipes, outlets,
fixtures, etc., which might be at ground potential. Keep your body isolated from ground by using dry
clothing, rubber shoes, rubber mats or any other approved insulating material.
• Turn off power to the circuit under test before cutting, unsoldering, or breaking the circuit. Even small
amounts of current can be dangerous.
• Use caution when working above 60VDC or 30VAC rms as such voltages pose a shock hazard.
• When using the probes, keep your fingers behind the finger guards on the probes.
• Measuring voltage which exceeds the limits of the multimeter may damage the meter and expose the
operator to electrical shocks. Always respect the meter voltage limits as stated on the front of the meter.
• Never apply voltage or current to the meter that exceeds the specified maximum:
Input Limits
Function
VDC or VAC
mA DC/AC
A DC/AC
Frequency, Resistance, Capacitance, Duty Cycle,
Diode test, Continuity
Temperature
DVM9912
Max. Output
600VDC, 600VAC
400mA DC/AC
10A DC/AC (30 seconds max every 15 minutes)
250V DC/AC
250V DC/AC
3
VELLEMAN