Cleaning, Maintenance And Ordering Spare Parts - EINHELL TE-MS 18/210 Li Traduction Du Mode D'emploi D'origine

6.10 Operating the laser (Fig. 2)
Switching on: Move the On/Off switch (36) to
the "I" position to switch on the laser (35). A laser
line is projected onto the material you wish to
process, providing an exact guide for the cut.
Switching off : Move the On/Off switch (36) to the
"0" position.
6.11 Operating the LED lamp (Fig. 2)
For good illumination of the work area you can
use the LED lamp in addition to the room lighting.
The On/Off switch (24) for the LED lamp is on the
top of the machine head, between the handle (1)
and the mount for the rechargeable battery.
Switching on: Switch position "I"
Switching off : Switch position "0"
6.12 Electric brake
For safety reasons, the equipment is supplied
with an electric brake system for the saw blade.
The equipment may therefore emit an odor or
generate sparks when it is switched off . This has
no infl uence on the operational performance or
safety of the equipment.
6.13 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.14 Battery capacity indicator (Fig. 15 / item
44)
Press the battery capacity indicator switch (45).
The battery capacity indicator (44) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
Anl_TE_MS_18_210_Li_SPK7_USA.indb 21 Anl_TE_MS_18_210_Li_SPK7_USA.indb 21
EN
7. Cleaning, maintenance and
ordering spare parts
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
7.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked by a qualifi ed electrician.
Danger! The carbon brushes should not be
replaced by anyone but a qualifi ed electrician.
7.3 Maintenance
There are no other parts inside the equipment
which require maintenance.
7.4 Ordering replacement parts:
Service
1. If your power tool requires service,
contact an authorized Einhell USA dealer
or call the Einhell USA customer service
center at 1-866-EINHELL
(1-866-346-4355). Only identical
replacement parts should be utilized for
repairs. This will ensure that the safety of the
power tool is maintained.
2. If the battery charger cable is damaged, it
must be immediately replaced to avoid a
hazard. Contact the Einhell USA
service center at 1-866-EINHELL
(1-866-346-4355) for assistance.
- 21 -
customer
®
05.08.2019 14:05:52 05.08.2019 14:05:52