Cleaning The Milk System - Bosch TCC78K751 Mode D'emploi

Masquer les pouces Voir aussi pour TCC78K751:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

52 | English
7. Wipe out the inside of the tray holders.
8. Clean the milk frother (procedure de-
scribed below).
9. Replace all the parts again.
Important: Drip tray for coffee
outlet (27) and coffee grounds
container (28) should be emptied
and cleaned daily to prevent
mould from developing.
If the appliance is switched off
using the button (3)
and switching off) or it switches
off in accordance with the "Auto
off after" settings, the rinsing
process will automatically
take place. In other words the
pipework inside the appliance is
cleaned by the machine itself.
Important: If the appliance has
not been used for a prolonged
period of time (e.g. after a vaca-
tion), clean the entire appliance
thoroughly, including the milk
system and brewing unit.
Bosch
TCC78K751_Heft1.indb 52

Cleaning the milk system

irst before touching.
The message
Please short rinse the milk system
Press
appears
– if cleaning has not been performed after
(rinsing
use
Z
– if the appliance has just switched off
automatically and it was not cleaned
beforehand.
If this message appears, start with Step 2
under "Short rinse for milk system".
Clean the milk system immediately after use.
Short rinse for milk system:
1. In the menu for drink selection, select
2. Place a cup under the milk frother (12)
3. Press
4. Empty the cup and clean the milk tube.
Risk of burns
The milk frother (12) gets very
hot. After use, allow to cool down
o
Short rinse
and press
and the end of the milk tube in the cup.
o
start/stop (10). The appliance
now ills the cup automatically with water
and draws it in again through the milk
tube for rinsing. The rinse procedure
takes about 1 minute.
All the parts can also be
put in the dishwasher.
.
start/stop (10).
o
TCC78K751 | 07/2011
28.06.2011 11:44:23

Publicité

Table des Matières
loading

Table des Matières