Calc'n'clean - Bosch TCC78K751 Mode D'emploi

Calc'n'Clean

Calc'n'Clean combines the separate func-
tions of descaling and cleaning. If the two
programmes are both due to run soon, the
fully automatic espresso machine suggests
this service programme automatically.
Service - Calc'n'Clean
If the prompt
Start with O
played, press and hold down
three seconds. The display shows:
Calc'n'Clean
or
To start without the prompt (see „Displaying
Start with O
Settings") press and hold down
least three seconds and select
Calc'n'Clean
Press start/stop (10). The display will
o
guide you through the programme.
Empty drip tray
Empty the drip tray (22).
Replace drip tray
Replace the drip tray.
If the milk frother is not inserted,
the following message is displayed:
Set up milk frother
Press O
Insert the milk frother (12)
Place container under milk frother
Place a container with a capacity of at
least one litre under the milk frother (12).
Press o start/stop (10). The appliance
rinses twice:
Cleaning
Open drawer
Deploy the appliance and open the
drawer (19).
Bosch
TCC78K751_Heft1.indb 57
Insert cleaning tablet!
Close drawer!
Press O
is dis-
Remove filter
(9) for at least
k
Remove the water filter and
Press O
press
Add 0.5 l water and descaler
(9) for at
k
Descaling
Press O
Not enough descaling fluid
Refill fluid
Pour lukewarm water into the empty
water tank (14) up to the calc (0.5 litre)
mark and dissolve two descaling tab-
lets in it. Press
Press O
descaling programme will continue.
Clean and refill water tank
Drop a cleaning tablet in the drawer and
close the drawer again.
If the water ilter is activated, the
following message is displayed:
start/stop (10).
o
Pour lukewarm water into the empty
water tank (14) up to the calc (0.5 litre)
mark and dissolve two descaling tablets
in it. Press start/stop (10).
o
The descaling programme now runs for
about 20 minutes:
If there is not enough descaling
luid in the water tank, the fol-
lowing message is displayed:
start/stop (10). The
o
Rinse the water tank and reill it with
fresh water up to the "max" mark.
Press o start/stop (10).
The descaling programme will now run
for about 1 minute:
English | 57
TCC78K751 | 07/2011
28.06.2011 11:44:26