•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.
5.3 Operation
Before first use
•
Before first use wash the device with warm water and a mild cleaning agent. Clean
with water again so as to remove detergents from the surface. Finally, wipe the
device dry thoroughly.
•
Attach the drip tray at the back of the device.
•
Plug the device into a correctly earthed electrical socket.
•
Heat the device without any food at the highest temperature setting for about 5 minutes.
If this is the very first use, some smoke may be present. It is not dangerous and smoke
should appear no more during further use of the device.
•
Turn the device off (set temperature adjustment knob to „OFF" position) and allow it
to cool down.
Temperature setting
•
Temperature is infinitely variable and set with a temperature adjustment knob.
•
Set temperature by turning the adjustment knob clockwise to the required position
starting from „OFF" position.
Temperature adjustment ranges are shown in the picture below.
Setting indicator
- 24 -
Temperature set at approx. 250 ° C
Temperature set at approx.50° C
Heating light