Reverse Display; Factory Defaults - Cameo CLSCAN60W Manuel D'utilisation

REVERSE DISPLAY

Using this function, the characters in the display can be reversed by 180°.
Press the MODE button and then use the UP and DOWN buttons to select
the reverse display function ("r d l S" appears in the display). Now press the
ENTER button and use the UP button to select reverse on (ON) or the DOWN
button to select reverse off (OFF)
Confirm with ENTER.
FIXTURE TIME
Using this function, the fixture time can be displayed.
Press the MODE button and then use the UP and DOWN buttons to select
the fixture time display ("F l t l" appears in the display). Now press the
ENTER button. The display shows the number of hours for which the unit has
already been in operation.
RESET
Use this function to start the motor reset process.
Press the MODE button and then use the UP and DOWN buttons to select
the reset function ("r E s t" appears in the display). Now press the ENTER
button. The rest process begins and after approx. 20 seconds the motors are
recalibrated and the unit is operational.

FACToRY DEFAULTS

You can use this function to reset the unit to the factory default settings.
Press the MODE button and then use the UP and DOWN buttons to select
"LOAd". Now press the ENTER button. All settings (microphone sensitivity,
reverse display...) have now been reset to the factory defaults. The unit is
immediately operational again.
NoTE
If one of the 4 buttons is not pushed, the LED display
switches off automatically after approx. 70 seconds. As soon as one of the
four buttons is pressed, the display switches on again automatically.
11