Replacing Light Bulb (Only Model With Light) - Hitachi C 18DMR Instructions De Sécurité Et Mode D'emploi

Scie circulaire sans fil
Masquer les pouces Voir aussi pour C 18DMR:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NOTE:
Thoroughly remove any sawdust which
has accumulated on the spindle, bolt and
washers.
To assure proper rotation direction of the
saw blade, the arrow direction on the saw
blade must coincide with the arrow
direction on the saw cover.
Using the fingers, tighten the left-hand
bolt retaining the saw blade as much as
possible. Then depress the lock lever,
lock the spindle, and thoroughly tighten
the left-hand bolt.
CAUTION:
After mounting the saw blade, reconfirm
that the lock lever is firmly secured in the
prescribed position.

REPLACING LIGHT BULB (ONLY MODEL WITH LIGHT)

WARNING:
Make absolutely sure that the battery is removed from the main body before
replacing the light bulb.
Immediately after the light is turned OFF, the bulb retains high temperature. Make
sure to cool down the light bulb thoroughly before replacing it so as to prevent burns.
CAUTION:
When replacing the light bulb, check the shape of base as well as the rating (12 V, 5 W),
and then carry out perfect mounting. Otherwise, the light bulb can come off and/or
cause overheat.
lower guard lever
Fig. 19
Left-hand bolt
Washer (B1)
Concave
Fig. 20
English
Saw cover
Washer (A1)
Ring
Spindle
Saw blade
27

Publicité

Table des Matières
loading

Table des Matières