Hitachi C 18DMR Instructions De Sécurité Et Mode D'emploi page 24

English
CAUTION:
Don't remove circular saw from workpiece during a cut while the saw blade is
moving.
Pull out the battery after completing operation.
NOTE:
Take care not to lock the motor. If the motor is locked, immediately turn the power off.
If the motor is locked for a while, the motor or battery may be burnt.
1. Operation of switch (Switch trigger and light switch)
For safe operation of the machine, a
"switch lock" is provided on the side of a
handle.
If the "switch lock" is pulled in a state
where it is pressed in the direction of the
arrow mark, the
turned ON.
〈Only model with light〉
(1) Switch lock is used as the "light switch".
If the "switch lock (light switch)" is pulled
in a state, the light is turned ON.
(2) After the switch is turned ON, even when
you release your hand from the switch
lock, the body continues running and the
light continues being turned ON as long
as you keep on pulling the switch trigger.
(3) If you release the switch trigger, you can turn OFF the switch and the "switch lock" returns
to the original position automatically and the light turns OFF too.
2. Working performance per single charge (Reference data)
Cutting capability differs according to the condition of lumber, type of saw blade, ambient
temperature, battery characteristics, etc.
2 × 8 (Spruce-Pine-Fir)
Concreteform plywood (1/2" (12 mm) t)
To improve working efficiency per single charge,
Minimize operation (no-load operation) other than cutting;
Avoid any unreasonably forced pressure to the motor during cutting operation by
twisting or pressing the circular saw forcibly;
Avoid any use of dull saw blade.
24
main switch can be
Wood
Switch trigger
Switch lock
* (It works
as switch
lock alone
if the
machine is
not
equipped
with light.)
Fig. 13
Capacity
EB1820L
80 (cuts)
100 ft (30 m)
EB1830HL
110 (cuts)
133 ft (40 m)