Wire Ropes - Tractel tirfor TU Série Manuel D'installation Et D'entretien

Clean the pin housings. Replace the forward lever on
its shaft, and in the case of a TU
ensure that the half-housings of the axis are lined up
with those on the lever.
TM
TU 6PM
TM
TU 12PM
TM
TU 24PM
Push the new pins fully into their housings by
tapping them in lightly with a hammer, after
lining up the holes on the upper and lower parts
TM
of the lever (model TU
TM TM
6PM or TU 12PM
24PM).
WARNING : Sheared pins should only be
replaced with tirfor
Before putting the equipment back into
operation, ensure that the cause of the
overload has been removed. If necessary the
loads in the cradle must be redistributed.
A supply of spare pins should be kept to avoid
prolonged operating stoppages.

10. WIRE ROPES :

WARNING: To guarantee the safe operation
®
of tirfor and blocstop™ devices it is
essential that they are only used with tir-
for ® wire ropes, which have been specially
designed for this equipment and are of the
correct strength, as specified in the
REMINDER: Using a wire rope other than
the tirfor ® special
mechanism in the tirfor
blocstop™ safety device constitutes a
modification to the lifting system and
removes the CE certification from the
assembly.
European standards.
One end of the wire rope has a safety hook atta-
ched to a loop of the wire rope. This loop is fit-
ted with a thimble and crimped in a metal slee-
ve. The other end of the wire rope is
1.5 mm
Ø11.5 mm
max. 1,5 dia.
13
® pins of the same type.
wire rope in
®
hoist or the
dia.
GB
a