Standard Delivery; Assembly Layouts - Tractel tirfor TU Série Manuel D'installation Et D'entretien

The load is transferred to the operating levers
(forward or reverse) via a removable telescopic
operating handle.
The equipment is fitted with an anchoring
device ie a hook or pin, depending on the
model, for quick attachment to the anchorage
point on the stirrup
suspended platform, which must be sufficiently
strong.
The tirfor® winch complies with the standards
EN1808(08/99) and EN13157, the machine
directive 2006/42 / EC and its amendment lifting
person.
1.2. blocstop™ safety device
The blocstop™ safety device, for temporary
suspended platforms, is a safety device special-
ly designed for lightweight suspended platforms
fitted with two manual hoists.
The blocstop™ safety device complies with
standard EN 1808(08/99) and the amendment
of the machinery directive concerning the lifting
of personnel.
To provide a coherent protection system which
prevents the platform
blocstop™ safety device is fitted on the secon-
dary rope, which
separate from, the suspension rope.
The secondary rope does not take the load
during normal operation. If the suspension rope
breaks, the hoist fails or there is a significant
incline, the blocstop™ and the secondary rope
support the platform on the side where the fault
has occurred.
A standard installation necessitates the separa-
te purchase of a blocstop™ and two wires ropes
equipped with safety hook.
IMPORTANT : The wire ropes for tirfor
TM
TU P devices are specially designed to be
used with tirfor ® personnel lifting devices
and blocstop™, in accordance with the
special design of this equipment. These
wire ropes consist of five or six strands.
TRACTEL SAS cannot
operational safety
blocstop™ devices used with wire ropes
other than the recommended tirfor
ropes. The suspension rope and the
secondary rope must be identical.
of the temporary
from falling, the
is identical to, but
guarantee the
of tirfor ® and
® wire

1.3 Standard delivery

A standard delivery is composed of:
- a device with its telescopic lever
- this manual
- the installation, use and maintenance manual
ref.150425 for use of the tirfor® in lifting equipment
load
- the declaration of incorporation ref.135855
- the EC declaration of conformity ref.228145
2.

ASSEMBLY LAYOUTS:

2.1. tirfor ® hoist:
For use on an ALTA L or TANGOR platform, the
TM
two TU 6PM hoists are attached to the end
stirrups (see the manuals for the ALTA L and
TANGOR platforms) using a fastener bolted on
the lower bar of the stirrup.
For use on special platforms, the tirfor
TM TM
TU 6PM, TU 12PM and TU
must be hooked onto a special support on the
personnel lifting device. This support must be
strong enough to comply with the working
coefficient value
applicable standards, and at least 4. In Europe,
a special platform must be subject to an CE
type-approval by a notified body.
N. B.: Whatever the assembly layout, if the devi-
ce is anchored directly to a fixed point, it must
be possible for it to be aligned with the direction
of the load or effort with no restriction. To ensu-
re anti-tilt protection,
instructions for the blocstop™ BSA 15 301,
BSA 20 301 and BSA 35 30 device must be
followed.
2.2. blocstop™ safety device:
The platform is fitted with two manual hoists,
®
and with a maximum length of 12, 15 or 18
metres, depending on the platform and the stir-
rups used (see the ALTA L, S or TANGOR
"temporary suspended
manual).
5
TM
24PM hoists
recommended in the
the assembly
platform" operating
GB
®