wallas 88DU Instructions D'installation, De Fonctionnement Et D'entretien page 81

Installation
SPECIFIC INSTRUCTIONS FOR INDIVIDUAL LEAD-THROUGHS
2467 Side lead-through
A side lead-through is installed in the side of the boat or in the transom. In sail
boats it is recommended to install it in the transom. The installation always requires
a so-called swan neck piece.
Make the necessary installation cut-outs and spread a suitable sealing agent on
both sides of the seal and on the screw holes. This will ensure that the connection
is waterproof.
88DU
min 150 mm
2448
Side lead-through 2467 installed.
The installation cut-out is ø 50
mm and the screw holes are 4 x
ø 6 mm
- 81 -
GB
2467
ø 74 mm
125 mm
max 25 mm
490070GB