wallas 88DU Instructions D'installation, De Fonctionnement Et D'entretien page 70

Installation
Fastening the device
Place the stove in the installation cut-out and attach the iron fasteners (3) with the
screws (5) to the rivet nuts at the ends. After this, install the cover plug (8) on the
end of the screw and tighten the iron fasteners against the table with the screw (6).
Remember the locking nuts (7).
Use the screws (4) in the accessory bag to fasten the control panel to the table.
Connect the power cord (2) to the connector in the
cooling case of the stove.
8
Thin table
The iron fasteners can be installed in two ways depending on the thickness of the table board.
Tighten the screw (6) fi rmly against the table board and then tighten the locking nut (7).
1
88DU
Attach the iron fasteners to the stove (3) with
screws (5).
3
Thick table
7
6
Push the cover plug (8) on the screw.
Connect the control panel cable from the
device to the control panel (1).
Use the fastening screws to install the
control panel to the installation cut-out (4).
4
- 70 -
GB
5
490070GB