wallas 88DU Instructions D'installation, De Fonctionnement Et D'entretien page 77

Tank-external fi lters
Filters can be installed in a ø5 or ø6 mm plastic or
fuel pipes are clean before installing the fi lter. There must be no debris or impurities
between the pump and the fi lter as they will clog the pump. The fi lter type must be
selected according to the operating conditions and country-specifi c requirements.
Fuel fi lter 30015
The fi lter is supplied with the stove.
The fi lter can be installed directly in the 30011 tank connection by using a ø 6 mm
rubber hose (20) and 10 mm hose binders (18).
Alternatively, the fi lter can be installed between two ø 5 mm fuel hoses with ø 5 mm
rubber hose (19) and ø 8 mm hose binders (17).
Air bubble
Fuel fi lter 30014 (accessory)
This fi lter is intended for cold conditions.
The fi lter can be installed directly in the 30011 tank connection by using a ø 6 mm
≈ 20 - 90°
barrel nut and 6 mm olive.
Alternatively, the fi lter can be installed between two ø 5 mm fuel hoses with ø 5 mm
barrel nut, ø 5 mm olive and ø 2 mm support sleeve.
Fuel fi lter 30016 (accessory)
Used in countries where a metallic fuel transfer system is required. A
is used for the installation.
88DU
Installation
19
Install the fi lter in the direction of the
arrow on it.
For connecting a ø 5 mm
fuel hose
Sinter bronze fi lter
Filter's brass frame
- 77 -
/ '' metal pipe. Ensure that the
1
8
17
16
Seal
GB
18
17
20
19
For connecting a ø 5 mm
fuel hose
For connecting a 30011
tank connection
/ " metal pipe
1
8
Olive connection / "
1
8
490070GB