Parkside PPWS 230 A1 Manuel D'utilisation page 38

˜ Fitting the cutting guard
attachment
Fig. G
m WARNING! RISK OF INJURY!
Switch off the product and disconnect
it from the mains before making any
adjustments, performing maintenance,
cleaning and when the product is not
in use.
NOTE
For cut-off grinding, fit the cutting guard
u
attachment to the grinding guard
[ ]
1. Fit the cutting guard attachment
the side on which the running direction is
indicated.
2. Push the cutting guard attachment
the grinding guard
attachment clicks into place.
˜ Removing the cutting guard
attachment
Fig. G
m WARNING! RISK OF INJURY!
Switch off the product and disconnect
it from the mains before making any
adjustments, performing maintenance,
cleaning and when the product is not
in use.
1. Push the notch on the cutting guard
[ ]
attachment away from the grinding
[ ]
guard .
[ ]
2. Remove the cutting guard attachment
the grinding guard
˜ Fitting the additional handle
m CAUTION!
For safety reasons, this product may only
u
be used with the additional handle
Failure to do this can lead to serious injury.
The additional handle can be screwed onto
the left or the right depending on the job at
hand.
36 GB/IE
.
[ ]
with
[ ]
onto
[ ]
until the cutting guard
[ ]
from
[ ]
.
[ ]
.
[ 8 ]
Depending on the method of working, tighten the
handle on to the handle thread on the left/right/
top of the product.
˜ Fitting/changing the grinding/
cutting disc
Fig. D, E
m WARNING! RISK OF INJURY!
Switch off the product and disconnect
it from the mains before making any
adjustments, performing maintenance,
cleaning and when the product is not
in use.
Always wear protective gloves when changing
grinding disc or cutting disc. The grinding or
cutting disc is very hot after use. Allow the grinding
or cutting disc to cool down completely before
touching them.
Pay attention to the dimensions of the grinding disc
or cutting disc. The diameter of the disc bore must
fit the mounting flange without any play. Do not use
a reducer or adapter.
Check the grinding disc or cutting disc. It
should not be damaged or damp, and it should
have no cracks. Otherwise, it could break
during use and cause injuries.
NOTE
Use only discs which are free of dirt.
u
Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool. Use only discs
who have not passed the expiry date.
m CAUTION! RISK OF INJURY!
Press the spindle locking button
u
when the attachment spindle
complete standstill.
1. Press the spindle locking button
spindle.
2. Undo the locking flange
mounting spanner
[
only
[ ]
is at a
[ ]
to lock the
[ ]
using the two-hole
[ ]
(Fig E).
]