Scope Of Delivery; Specifications; Safety Notes - EUFAB 16647 Manuel De L'opérateur

Chargeur de batterie intelligent 6/12 v 4 a également pour les batteries au lithium
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18

2. SCOPE OF DELIVERY

• 1x Charger

3. SPECIFICATIONS

Dimensions:
approx. 185 x 70 x 45 [mm]
Weight:
approx. 0.420 kg
Long mains cable: 1.50 m
Long charger cable: 1.50 m

4. SAFETY NOTES

• Keep children away and do not let children operate this appliance!
• Use this product only for its intended purpose!
• Do not tamper with or disassemble the unit!
• For your own safety, only use accessories or spare parts that are specified in the instructions or whose use
is recommended by the manufacturer!
• The warning triangle labels all instructions important to safety. Always follow these otherwise you could
injure yourself or damage the device.
• Do not smoke or light an open fire while working on the battery. There is a risk of explosion.
• Only connect the appliance to a properly installed socket. The voltage must correspond to the specification
on the type plate of the appliance.
• Do not trap the power cable and protect it from sharp edges, damp, heat or oil. The power cable of the unit
cannot be replaced. In the event that the cable is damaged, the unit must be disposed of.
• Do not operate the device or immediately pull the plug if it is damaged or you suspect it may be defective.
In this case, contact our technicians.
• Pull the plug when the device is not in use.
• Keep packaging materials, especially plastic and plastic bags, away from children. Risk of suffocation!
• Remove all plastic from the device before use.
• Lay the mains cable in such a way that you are not hindered by it, and no one is able to accidentally pull it.
• Disconnect the battery charger from the power supply after charging.
• Keep the charger in a place that cannot be accessed by children or unauthorised persons.
• Never operate the device in the vicinity of flammable materials or in an environment prone to explosion.
• Always wear suitable working clothes, protective gloves and goggles. Battery acid is corrosive!
Immediately and thoroughly wash off any splashed acid and consult a doctor if necessary. If battery acid
gets into the eyes, immediately rinse under running water for at least 10 minutes and consult a doctor.
• Do not cover the charger, this may lead to overheating and result in damages. Never set the charger up for
operation on a surface that is insulating (e.g. polystyrene). There is a risk of heat build up!
• If you wish to charge a vehicle battery in the installed state, first park the vehicle safely, put on the
parking brake and switch off the ignition. Cut the battery off from the on-board network of your vehicle.
To do this, consult the manual for your vehicle, or ask your specialist workshop.
• To remove the battery charger, first disconnect the mains plug from the socket and observe the sequence
when disconnecting. This will prevent sparks from forming. As highly explosive oxyhydrogen gas is
produced during charging, this is extremely important for your protection.
• When pulling the mains cable out of the socket, only hold the plug.
• Never expose the charger to the vicinity of fire, heat and extensive temperatures over +40°C.
• Do not leave the charger unattended during charging.
• Store these instructions carefully and, if necessary, pass them on to other users.
• 1x Operating instructions
Input:
Output:
Battery capacity
Ambient temperature: -5 °C to +40 °C
220-240 V AC 50/60 Hz
6 V mode:
7.2 / 7.4 V, 2 A
12 V mode:
14.4 /14.8 V, 2 / 4 A
(further data in section 6.4.1)
1.2 - 120 Ah
11

Publicité

Table des Matières
loading

Table des Matières