Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Alternate mowing direction. This helps disperse
clippings over lawn for even fertilization.
If the finished cut lawn appearance is unsatisfactory,
try one or more of the following:
Sharpen the blade.
Walk at a slower pace while mowing.
Raise the height-of-cut setting on your mower.
Cut grass more frequently.
Overlap cutting swaths instead of cutting a full
swath with each pass.
Mow across the marginal areas a second time.
Set height-of-cut on front wheels one notch
lower than rear wheels. (example: set front
wheels at "C" setting and rear wheels at "D"
setting)
Cutting Leaves
When cutting is complete, always be sure that
50% of the lawn shows through the cut leaf
cover. This may require one or more passes over
the leaves.
For light leaf coverage, position all wheels at the
same height-of-cut setting.
If there are more than five inches of leaves on
lawn, set the front wheels one or two notches
higher than the rear wheels. This makes it easier
to feed leaves under mower deck.
Walk at a slower mowing speed if leaves are not
being cut up finely enough to be hidden down in
the grass.
If you cut up a lot of oak leaves, you might want
to add lime to your grass in the spring. Lime
reduces the acidity of oak leaves.
GB–10
Operation
Starting, Stopping And
Self–propelling
CONTROLS—Throttle, blade control bar,
self–propel control bar (self–propelled model only)
and recoil starter are on upper handle (Fig. 9).
1.
Push spark plug wire onto spark plug (Fig. 8).
2.
STARTING (Fig. 9)—Move throttle forward to
FAST position.
Push primer three (3) times (Fig. 8). Wait about
two (2) seconds between each push.
Note:
Do not use primer to restart a warm
engine after a short shutdown.
However, cool weather may require
priming to be repeated.
Squeeze blade control bar against handle. Pull
recoil starter out until slack in rope is taken up.
Then pull vigorously to start the engine. When
engine starts, regulate engine speed as desired.
3.
STOPPING (Fig. 9)—To stop engine, release
blade control bar. Pull wire off spark plug if
mower will be unattended or not used.
4.
WHEEL TRACTION OPERATION
(self–propelled model) (Fig. 9)—Squeeze
self-propel control bar against handle to drive.
To stop the self–propel drive, release the
self-propel control bar.
Note:
The drive wheels are equipped with
freewheeling clutches which enable the
mower to be pulled rearward easier
when the wheel drive is disengaged. To
disengage the clutches, mower must be
pushed forward at least 2.5 cm (1")
after wheel drive operation has
stopped.
Using Discharge Tunnel Plug
1.
Stop engine.
Publicité
Chapitres
Table des Matières
