Invacare Matrx Elite PBE Manuel D'utilisation page 7

Accommodating Back Cane Size
 On some wheelchairs, there may be an uneven seam along the back posts where a smaller
diameter tube is inserted into a larger diameter tube. If the cane clamps must be mounted over
this seam, the plastic inserts may be cut in half to allow the clamp to fasten securely onto the back
posts (see image B).
For wheelchairs with short back canes, it may be necessary to install Matrx Posture Back Cane
Replacements (PBCR's). The PBCR's are designed to replace existing push handles or cane
extensions
onto the replacement back canes in order to allow proper installation of the Invacare Matrx Elite
back. Cane replacements are available from Motion Concepts (part#-TRX2810).
• 1" (25 mm) back cane - Cane clamps are installed without plastic inserts.
• 7/8" (22 mm) back cane - Requires 7/8" (22 mm) plastic inserts.
• 3/4" (19 mm) back cane - Requires 3/4" (19 mm) plastic inserts.
A
Plastic Insert
Part No 1171724
on standard 1" (25
PBCR
) back posts. The cane clamps can be
mm
B
7
mounted directly
The plastic insert may
be cut if the cane
clamp is secured at the
junction of 2 different
diameter back posts.
Invacare® Matrx® Elite