Invacare Matrx Elite PBE Manuel D'utilisation page 4
INSTALLATION WARNING
The procedures in this manual should be performed by a qualified technician.
Risk of Serious Injury or Damage
Attaching hardware that is loosely secured could cause loss of stability resulting in serious injury or
damage.
After ANY adjustments, repair or service and before use, make sure that all attaching hardware is
tightened securely.
DO NOT install the Invacare Matrx Elite back assembly onto back canes with an outside diameter
greater than 1-inch or less than 3/4-inch. Otherwise, injury or damage may occur.
The mounting position of the Invacare Matrx Elite back is directly related to the chair's stability.
When the Invacare Matrx Elite back is added to a TILT and/or RECLINING chair, it may cause a
decrease in the chair's stability. It may be necessary to reposition the FRONT CASTERS, REAR
WHEELS, BACK ANGLE, TILT-IN-SPACE, RECLINE POSITION and/or SEAT DEPTH before
use. Use extreme caution when using a new seating position.
Heavy-Duty Mounting Hardware (HDMH) must always be used in combination with all models of
Invacare Matrx Elite Heavy-Duty backs.
When an Invacare Matrx Elite is added to a TILT and/or RECLINING chair, a RIGIDIZER BAR or
CROSSBAR must be present to stabilize the back canes.
Ensure the Invacare Matrx Elite back is properly secured to the wheelchair before using.
Otherwise injury or damage may occur.
2.5
Invacare Matrx Elite Back Weight Limitation and Model Numbers
Refer to the chart for the weight limitation and stock model numbers.
Configured model numbers are: PBE and EDB
PBE = Elite Back, PBE-HD = Elite Back Heavy Duty, PBE-TR = Elite TR Back, PBE-TRHD = Elite
TR Back Heavy Duty, EDB = Elite Deep Back, EDB-HD = Elite Deep Back Heavy Duty
CONFIGURED MODEL
PBEwwhh
STD
EDBwwhh
PBEwwhh-TR
PBEwwhh-HD
HD
EDBwwhh-HD
PBEwwhh-TRHD
* wwhh = width/height
Back sizes (width/height) will vary depending on the model of Elite Back. Please contact your dealer or
Therapist to determine the appropriate back model/size for your individual needs.
For further information on any of our Matrx backs, including all available models/sizes, please visit
www.motionconcepts.com or www.invacare.com.
Invacare® Matrx® Elite
DESCRIPTION
Elite Back
Elite Deep Back
Elite TR (Tilt/Recline) Back
Heavy Duty Elite Back
Heavy Duty Elite Deep Back
Heavy Duty Elite TR (Tilt/Recline) Back
4
CONTOUR
WEIGHT
DEPTH
CAPACITY
3 in. (76mm)
6 in. (152mm)
300 lbs. (136 kg)
3 in. (76mm)
3 in. (76mm)
6 in. (152mm)
500 lbs. (227 kg)
3 in. (76mm)
Part No 1171724
