Saw Blade Mounting And Dismounting - Hitachi C 12FSA Mode D'emploi Et Instructions De Securite

English
Cutting depth adjustment procedure:
(1) Loosen the 8mm wing nut and turn the 8mm depth adjustment bolt by hand.
(2) Adjust to the desired cutting depth by setting the distance between the saw blade and the surface of
the base (see b in Fig. 37).
(3) The 8mm wing nut must be properly tightened after the adjustment has been completed.
NOTE:
When cutting a single groove at either end of the workpiece, remove the unneeded portion
with a chisel.
12. Cutting easily-deformed materials, such as aluminum sash
Materials such as aluminum sash can easily deform when tightened too much in a vise assembly. This will
cause inefficient cutting and possible overload of the motor.
When cutting such materials, use a wood plate to protect the workpiece as shown in Fig. 39-a. Set the wood
plate near the cutting section.
When cutting aluminum materials, coat the saw blade with cutting oil (non-combustible) to achieve smooth
cutting and a fine finish.
Furthermore, if the material flutters during cutting in the lateral direction as well, tighten it with the help of
a vise (A) (Code No. 305174) sold separately. (Fig. 39-b)
Fence
8mm Knob Bolt
13. How to use the dust bag (Standard accessory)
Duct
Dust Bag
Right
Angle
Base
Fig. 40
CAUTION:

SAW BLADE MOUNTING AND DISMOUNTING

WARNING:
To prevent an accident or personal injury, always turn off the trigger switch and discon-
nect the power plug from the receptacle before removing or installing a saw blade.
If cutting work is done in a state where the bolt is not sufficiently tightened, the bolt can
get loose, the blade can come off, and the safety cover can get damaged, resulting in
injuries.
22
All manuals and user guides at all-guides.com
Vise
Assembly
Wood
Plate
Aluminum
Sash
Wood Plate
Fig. 39-a
(1) When the dust bag has become full of sawdust, dust will be
blown out of the dust bag when the saw blade rotates.
Side Cover (R)
Check the dust bag periodically and empty it before it becomes
full.
Side Cover (L)
(2) During bevel and compound cutting, attach the dust bag at a
right angle to the base surface as shown in Fig. 40.
Empty the dust bag frequently to prevent the duct and the safety cover from becom-
ing clogged.
Sawdust will accumulate more quickly than normal during bevel cutting.
Fence
8mm Knob Bolt
Fig. 39-b
Vise
Assembly
Wood Plate
Vise (A)
(Optional
Accessory)
Aluminum Sash