Inserting The Battery; Charging The Battery; Setting The Display Language; Auto Answer - switel DF 1201 Mode D'emploi

Preparing the Telephone

Inserting the battery

Remove the back cover of the handset by grasping with a suitable device,
such as your fingernail, in the recess between the charging contacts and
raise the cover.
Insert the battery into the battery compartment.
Put on the back cover by placing it flat on the back of the handset and press
it down all around until it clicks. Have a look at the handset again around
from the side, whether the coverage gap is attached firmly.
a
Attention: Use only the 3.7 V- Li-Ion batterie supplied.
Observe the correct polarity!

Charging the battery

☞
Before the handset is used for the first time, insert it in the base station /
charging station for at least 8 hours.
The handset warms up during the charging process. This is normal and
does not represent a risk. Use only the adapter plug unit provided for the
base/charging station. The battery status is shown on the display. When the
battery capacity is nearly exhausted, the battery symbol will flash in the dis-
play and you will hear the battery warning sound.
Setting the time and date
At initial operation the handset does not have the correct time (e.g. for
entries in the call list). Date and time are set through the menu item "BASE/
Time Set".

Setting the display language

The display language is available in several languages. The default setting is
"German (Deutsch)". Set the language using the menu item "MOBILTEIL /
SPRACHE".

Auto Answer

If this function is activated, an incoming call is taken when the handset is
removed from the base station. The automatic answering function is activat-
ed and deactivated using the menu item "HANDSET/ Auto Answer".
6