Care And Maintenance - Powerpeak Comfort Line Ftm8301P Mode D'emploi

Centering the running belt
When you run, you may place more pressure on the belt with one foot than with another. The severity
of this deflection depends on the amount of force that one foot exerts in relation to the other. This
deflection can cause the belt to move off centre. This deflection is normal and the running belt will
centre when nobody is on the running belt.
If the running belt remains consistently off centre, you will need to centre the running belt manually:
1. Place the device on a level surface.
2. Start the treadmill without anyone on the running belt, press SPEED+ button until speed reaches 5,6
km/h.
3. Observe whether the running belt is toward the right or left side of the deck.
a. If toward the left side of the deck:
Turn the left adjustment screw clockwise 1/2 turn, and the right adjustment bolt counter
clockwise 1/2 turn.
b. If toward the right side of the deck:
Turn the right adjustment screw clockwise 1/2 turn, and the left adjustment bolt counter
clockwise 1/2 turn.
c. If the belt is still not centered, repeat the above steps until the running belt is centered.
4. After the belt is centered, increase the speed and verify that it is running smoothly. Repeat the
above steps if it is necessary. If the above procedure is not successful in resolving the problem, you
may need to increase the belt tension.

CARE AND MAINTENANCE

Note: to prevent electrical shock, you need to make sure the treadmill is switched off and the plug
removed from the socket, before you start cleaning the device or before you perform regular
maintenance.
Treadmill and running belt lubrication
To achieve maximum life span this treadmill needs regular lubrication, as part of the general
maintenance program. This will prevent premature wear and tear of treadmill, running belt and motor.
Use
Less than 3 hours a week
3 – 5 hours a week
More than 5 hours a week
Oil
Annually
Every 6 months
Every 3 months
32