Initial Start Up - Scotsman Meridian HID312 Manuel D'installation Et De L'utilisateur

HID312 and HID525 50 Hz
Installation and User's Manual

Initial Start Up

Final check list:
1. Is the icemaker-dispenser installed indoors, in a
location where the air and water temperatures
are controlled, and where they do not go beyond
design limitations?
2. Is there an electrical disconnect (switch or
plug as required) within sight of the installed
machine? Is the machine on a separate circuit?
Has the voltage been checked and compared to
nameplate requirements?
3. Have all of the plumbing connections been made
and checked for leaks?
4. Has the machine been leveled?
5. Is there a minimum of 15 cm of clearance at the
left and right sides of an air cooled machine?
6. Is there clearance at the top and back of the
machine for service and utility connections?
7. Is there a water shut off valve installed near the
machine?
Start Up
1. Remove upper front panel
2. Open the water hand valve, observe that water
enters the water reservoir, fills and then shuts off.
Check for leaks. Repair any leaks before going
any further.
3. Switch electrical supply on. Lights on controller
will flash and then the power light will remain on.
The code display will show O.
4. Push and release the On/Off button. The machine
will start the ice making process. The code display
will show F. Air cooled models will discharge warm
air out the right side.
5. In minutes ice will begin to fall into the dispensing
bin. Check ice dispensing by holding a container
in front of the Touch Free ice sensor (just below
the ice delivery spout). Ice should flow from the
spout when a container is present, and stop
dispensing when the container is removed.
6. Check water dispensing by holding a container in
front of the Touch Free water sensor. Water will
flow when a container is present and stop when it
is removed.
7. Push the On/Off button to switch the machine off.
8. Unplug or disconnect electrical power.
9. Remove the top panel and the top of the ice
storage bin. Scoop out any ice in the bin and
sanitize the interior of the ice storage bin by
wiping it with a locally approved sanitizer.
10. Reconnect electrical power.
11. Push the On/off button to switch the machine on.
12. Replace all covers and panels.
13. Give the owner/user the user manual, instruct
him/her in the operation and maintenance
requirements of the unit. Make sure they know
who to call for service.
ON / OFF
April 2015
Page 9