Operation; Charging The Powerbank Of The; Charging A Mobile Device Using - Beurer LS 50 Travelmeister Mode D'emploi

5. Operation

5.1 Charging the powerbank of the LS 50
Fully charge the powerbank of the LS 50 prior to initial use.
To charge the powerbank, proceed as follows:
1. Insert the large end of the supplied micro
USB charging cable into a computer which is
switched on.
2. Insert the small end of the supplied micro USB
charging cable into the micro USB connection
of the LS 50.
3. Once the powerbank is completely charged,
all 4 bars of the battery state in the display of
the LS 50 are permanently visible.
4. When you remove the charging cable from the
LS50 after the charging process and switch it
on using the sliding switch, the bars for the bat-
tery state appear on the display (charging mode). To leave charging mode, wait 5 seconds
until the display switches off and then press the unit button/TARE button. "0.00" appears
on the display. You can only weigh luggage again once you have left charging mode.
5.2 Charging a mobile device using the LS 50
To charge your mobile device (e.g. smartphone) using the LS 50, proceed as follows:
1. Slide the sliding switch in the direction of the
unit button until it clicks into place. The LS50
is now switched on.
2. Connect the LS 50 with your mobile device
using the charging cable of your mobile device.
Note
If you have charged the LS 50 powerbank and
would like to charge a mobile device using the
LS 50 immediately afterwards, you must first of all
switch the LS 50 off and back on again.
Sliding switch
1 LED torch
2 LS 50 switched off
3 LS 50 switched on
12