Option Switch Rf Vub095; Description; Wiring - Jay Electronique Jump Notice D'installation

8 - Option switch RF VUB095

8.1- Description

This option ensures a continuous radio link in a congested RF environment (reflection,
shadow areas ...) by controlling an RF switch to transmit radio waves from two separate
antennas.
The VUB095 RF switch is controlled by the JUMP in accordance with the number of
configured frames (cf §4.2.6).
Ex: If the number of repeated frames is set to 6, the operating cycle will be as follows:
1. The JUMP will listen for 100ms on antenna1
2. The JUMP will retransmit for 100ms on antenna1
3. The JUMP will listen for 100ms on antenna2
4. The JUMP will retransmit for 100ms on antenna2
IMPORTANT: The maximum length of the cables connecting the JUMP repeater and the
RF switch must not exceed 30m.

8.2- Wiring

JUMP
TENS UNITS
CHARGE
B
A
ERROR
LD1
CONFIGURATION
LD5 J5
CONFIG
ERROR
FR EN
- 66 -
Antenna n°1
LD4
LD3
LD2
Module for increasing
radio coverage
VUB095
RF1 COM RF2
Jump - 332970E_A005
Antenna n°2
04/03/21