Jay Electronique Jump Notice D'installation page 54

4.2.4- Choice of operating mode (choice of transmission channel
relative to the reception channel)
Two radio operating modes are available. The choice of operating mode is
performed using the DIPswitch «configuration» and cursor No. 5.
TENS
CHARGE
A
ERROR
LD1
CONFIGURATION
LD5
CONFIG
ERROR
Mode 1 :
«Transmitter / repeater Jump / Receiver» system operates with the same radio
channel.
The received radio signal on the radio channel No. x is repeated on the radio
channel No. x. This operating mode is limited to a single repeater.
Caution: Never use multiple repeaters in mode 1 on the same «Transmitter
!
/ Receiver» pair. Except recommendation of Operating principle Nb 2.
«Operating
Mode 2 - 433MHz and 915MHz frequency ranges :
«Transmitter / reception Jump and transmission Jump / Receiver» system
operates with two different channels.
The received radio signal on the radio channel No. x is retransmitted on channel
No. y where y = x +10.
This mode allows multiple repeaters with a « Transmitter / Receiver» pair.
Caution : Considering the frequency jump performed, only the first 54
!
channels are available. If the channel is set above No. 54, a configuration
error is indicated by the Led LD5.
Configuration and example : Transmitter on channel No. 22, repeater Jump on channel No.
22 and receiver on channel 32.
Turn on the «Transmitter / Receiver» pair.
1.
Change the radio channel of the pair onto channel No. 32 (see procedure on product
2.
technical manuals).
Turn off the receiver.
3.
Change the radio channel of the transmitter onto channel No. 22.
4.
Turn on and configure the repeater onto radio operating mode 2 and radio channel No. 22.
5.
Enabling this mode is transcribed by a continuously flashing of the LED LD5.
Perform the «identity code learn» procedure (see Section 4.2.5).
6.
Turn on the «Transmitter / Receiver» pair, the radio message travels through the repeater
7.
from radio channel No. 22 to radio channel No. 32.
Verify proper operation by turning off the repeater Jump. The safety relays of the receiver
8.
must be deactivated in the duration of the passive shutdown of the system.
FR EN
- 54 -
LD4
LD3
UNITS
LD2
ON
B
1
CONFIGURATION
principle» section.
2 3 4 5 6 7
cursor No. 5
«ON» position = MODE 2
(trans. channel ≠ reception channel)
Position «OFF» = MODE 1
8
(trans. channel = reception channel)
Jump - 332970E_A005
See
04/03/21