Jay Electronique Jump Notice D'installation page 57

4.2.6- Configuration of the number of frames repeated
The Jump repeater can be configured for different repeat cycle.
The duration of a radio frame is 16ms. The number of frames must be
adjusted in according to the system reactivity and the robustness of
the radio link.
The number of radio frames is adjusted using the DIPswitch
«configuration» and cursor No. 6 and 7.
CHARGE
ERROR
LD1
LD5
CONFIG
ERROR
Cursor position table :
Cursor Cursor
nb.6 nb.7
ON ON
OFF ON
ON OFF
OFF OFF
Attention : Attention :
For the 920MHz For the 920MHz range -
fixed at 3 3 regardless of the position of cusrors 6 and 7.
fixed at regardless of the position of cusrors 6 and 7.
Jump - 332970E_A005
04/03/21
LD4
TENS UNITS LD3
LD2
B
A
CONFIGURATION
Number of frames repeated
range - channels from 16 to 31 channels from 16 to 31 - the number of repeated frames is
ON
1 2 3 4 5
CONFIGURATION
4
10
8
6
- the number of repeated frames is
Position «ON»
Position «OFF»
6 7 8
delay caused
64 ms
160ms
128 ms
100 ms (defautl)
EN FR
- 57 -