Jay Electronique Jump Notice D'installation page 55

Mode 2 - 920MHz frequency range :
s
«Transmitter / reception Jump and transmission Jump / Receiver» system
operates with two different channels.
The received radio signal on the radio channel No. x is retransmitted on channel
No. y where y = x +1.
This mode allows multiple repeaters with a « Transmitter / Receiver» pair.
Caution : Considering the frequency jump performed, Only channels 1 to 14
!
or 16 to 30 are available If the configured channel is equal to n°15 or greater
than n°30, a configuration error will be indicated by Led LD5.
Configuration and example : Transmitter on channel No. 22, repeater Jump on channel No.
22 and receiver on channel 23.
Turn on the «Transmitter / Receiver» pair.
1.
Change the radio channel of the pair onto channel No. 23 (see procedure on product
2.
technical manuals).
Turn off the receiver.
3.
Change the radio channel of the transmitter onto channel No. 22.
4.
Turn on and configure the repeater onto radio operating mode 2 and radio channel No. 22.
5.
Enabling this mode is transcribed by a continuously flashing of the LED LD5.
Perform the «identity code learn» procedure (see Section 4.2.5).
6.
Turn on the «Transmitter / Receiver» pair, the radio message travels through the repeater
7.
from radio channel No. 22 to radio channel No. 23.
Verify proper operation by turning off the repeater Jump. The safety relays of the receiver
8.
must be deactivated in the duration of the passive shutdown of the system.
Caution : for the channel No1 to No15
!
- A strict frequency plan must be put in place to ensure that the chosen
channel is available.
- If the selected channel is busy, the JUMP will not transmit until the channel
is free for 5 ms.
- After 300 ms without being able to emit, the jump will indicate the occupation
of the channel by a double flashing of the LD3 battery LED.
It will then be necessary to switch the JUMP off and on again.
Jump - 332970E_A005
04/03/21
.
EN FR
- 55 -